TC burrs - NON-FERROUS cut

PFERD has developed the NON-FERROUS cut for universal use on non-ferrous metals and fibre-reinforced plastics. This cut is characterized by its high stock removal rate.


  • Very good stock removal rate when used on non-ferrous metals such as brass and copper, plastics and fibre-reinforced plastics.
  • Reduced wear on the tool drive due to impact-free work without chatter marks, thanks to the high concentricity.

Materials that can be worked:

  • Bronze
  • Copper
  • Brass
  • Zinc
  • Fibre-reinforced plastics (GRP/CRP)
  • Thermoplastics


  • Milling out
  • Levelling
  • Deburring
  • Cutting out holes
  • Surface work
  • Work on weld seams

Matching tool drives:

  • Flexible shaft drive
  • Straight grinder
  • Robot
  • Machine tools

Recommendations for use:

  • If possible, use the tools on powerful drives with elastically mounted spindles to avoid vibration.
  • For the cost-effective use of burrs, work with higher rotational/cutting speeds.
  • Power recommendation for tool drives:
    • Shank diameter of 3 mm: 75 to 300 watts
    • Shank diameter of 6 mm: from 500 watts
  • Please observe the rotational speed recommendations.


TC burrs - ALU and NON-FERROUS cut

Here you can find additional useful information.

Download brochure


Cutting speeds, rotational speeds and cuts

Download brochure
chevron-leftAlertBrowse fileFileImagePdfWordTextExcelPowerpointArchiveCsvAudioVideoSpinnerSort NoneSort ASCSort DESC