TC burrs - STEEL cut

In comparison to conventional cross-cut burrs, the STEEL cut is characterized by up to 50 % higher stock removal rate when used on steel and cast steel.

Advantages:

  • Up to 50 % higher stock removal rate when used on steel and cast steel in comparison to conventional cross-cut burrs.
  • Significantly increased aggressiveness, large chips and very good chip removal through the innovative tooth geometry.
  • Workpiece is protected through much lower thermal load.
  • Reduced wear on the tool drive due to impact-free work without chatter marks, thanks to the high concentricity.

Materials that can be worked:

  • Steel
  • Cast steel

Applications:

  • Milling out
  • Levelling
  • Deburring
  • Cutting out holes
  • Surface work
  • Work on weld seams

Matching tool drives:

  • Flexible shaft drive
  • Straight grinder
  • Robot
  • Machine tools

Recommendations for use:

  • If possible, use the tools on powerful drives with elastically mounted spindles to avoid vibration.
  • For the cost-effective use of burrs, work with higher rotational/cutting speeds.
  • Power recommendation for tool drives: from 300 watts.
  • Please observe the rotational speed recommendations.

Safety note:

The very high stock removal rate can cause discolouration on the shank. This does not constitute a safety risk.

 

TC burrs - STEEL cut

Here you can find additional useful information.

Download brochure

 

Cutting speeds, rotational speeds and cuts

Download brochure

Products

chevron-leftAlertBrowse fileFileImagePdfWordTextExcelPowerpointArchiveCsvAudioVideoSpinnerSort NoneSort ASCSort DESC